C and CFR Style Efficiency Information

C Form Flex-Flex Couplings
The C Variety coupling consists of two flex hubs, one particular sleeve and a single accessory kit consisting of seals and snap rings.
CFR Sort Flex-Rigid Couplings
The CFR Form coupling include a single flex hub, a single rigid hub, 1 sleeve, one accessory kit consisting of seals and snap rings.
Simple and affordable variety of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in place
Offered as vertical and horizontal couplings
Wide number of exclusive variations for example full-flex, flex-rigid mill motor
Common configurations are available with the shelf
Ordering Facts
Application: Driver and Driven.
Type and dimension of coupling, horizontal, vertical etc.
Power: Motor horspower or torque requirement.
Speed: Motor RPM or Driven RPM.
Distance among shaft ends (BSE).
Shaft sizes.
C and CFR Variety Couplings
Ordering Information
Puller Holes are standard on sizes 4 by means of 12.
Puller Holes can be found for sizes 7/8 via three.five at an additional charge.
The BSE (distance In between Shaft Ends) may differ involving G and G1.
Interference bores without set screws are typical except if otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, check with Engineering Segment.
Greater sizes are available, please seek advice from Technical Assistance.